![]() |
|
|||||||||
Product Catalog |
Technical Info |
About Us |
Order Direct |
Dealers |
Contact
|
|
Callaham Pre-wired T Model Control Plate Assembly
A fully assembled and wired control plate using the best electronic components available, and our handcrafted hardware. Our control plate allows for full access to the switch lever which traditional control plates hinder. The heavy knurled knobs guarantee positive grip for sweaty fingers for swells.
Kit does not include Electrosocket. Must be purchased separately if needed. Note: 4-way comes with a diagram. 4-way wiring is as follows: bridge only, neck/bridge in parallel, neck/bridge in series, and neck only. Reverse wiring is where the control plate is installed rotated 180 degrees. The volume knob is first and the switch is to the rear. Additional Options:
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
For Ordering Instructions and Shipping Rates, go to our Order Direct page. |
Prices and Content subject to change without notice. |
© 1996-2023 by Callaham Guitars™. All rights reserved. Modified October 3, 2023 This website is protected by copyright and trademark laws under U.S. and International law. All images and content may not be reproduced without written permission of Callaham Guitars™. Stratocaster®, Strat® & Tele® are registered trademarks of Fender Musical Instruments Corp. Callaham Guitars™ is not affiliated with Fender Musical Instruments Corp. |
Callaham Guitars ™ |
Home |
Product Catalog |
Technical Info |
About Us |
Contact
Order Direct | Printable Order Form | Dealers Strat® Parts | Tele® Parts | Gibson® Parts | Bigsby® Parts |